- #How to enable mac filtering on uverse router how to
- #How to enable mac filtering on uverse router manual
- #How to enable mac filtering on uverse router Pc
Set the Passthrough DHCP Lease time to 99:0:0:0Ĭlick on the 'Home Network' tab, and then click on 'Wi-Fi' from the sub-menu.
#How to enable mac filtering on uverse router manual
Set Allocation Mode to Passthrough, set Passthrough Mode to DHCPS-fixed, and for the Passthrough Fixed MAC Address, either select your XR/router (if it's in there,) or manually input your XR/routers MAC address in the Manual Entry field (like I did in my picture.) Select 'IP Passthrough' from that same sub-menu that the last two steps were in. Ok, so IP Passthrough is NOT 'bridged mode,' but it is similar and will give you the results that you're looking for. Go down the list and turn off every single option in there.Īdvertisements Step 4: Enable IP Passthrough (aka Bridged Mode) Now click the 'Firewall Advanced' from the same sub-menu that you selected from before. Now click the button that says 'disable packet filtering.' Click the 'Firewall' tab at the top of the page, and then select 'Packet Filter' from the sub-menu. Once you're in your BGW, you will need to disable Packet Filtering. If so, you will need to log into your router/xr and check the status page and find the 'gateway' address - this will be the IP that you need to go to. Note: this address is the default IP address for your BGW and may be different.
#How to enable mac filtering on uverse router Pc
The following steps will assume that you have your network setup as follows: AT&T ONT > AT&T BGW > XR > PC Step 1: Login to the BGW The gist of what we’re going to do is this: Disable the wifi on the BGW, disable ALL firewall and packet filtering on the BGW, set the BGW to IP Passthrough, set the XR as the device that gets the public IP from the BGW passed to it, and finally, enable UPnP on the XR. I will be calling the Arris BGW210-700 the “BGW” and the Netgear XR500 the “XR” from now on.Īlright, enough of my rambling, let’s get to the fix. You will notice that if you plug a router into the BGW210, it will not work, and if it does, your devices will be Double NAT (being routed through 2 routers, and hitting each of their respective ‘firewalls’.) Which means that you almost certainly will not be able to play any games, stream, voice chat, etc. I’ve recently gotten AT&T Fiber (1Gbps Down x 1Gbps Up) at my house, and needless to say, it was a pain in my ass to get my router (Netgear XR500) to work with their Modem/Router combo (Arris BGW210-700.) I already had my router, and for the price that I paid for it, I wasn’t going to use their equipment to do my networking.
#How to enable mac filtering on uverse router how to
TL DR: These steps will show you how to essentially put your Arris BGW210-700 modem/router into “bridge” aka IP Passthrough mode, allowing you to use your Netgear XR500 (or pretty much any other router) as your router/wifi/firewall/etc.
0 kommentar(er)
